Application - Arturo PU3320 Floor Coating

Prior to the processing the Arturo PU7320 Floor Coating the following points are important:

  • Arturo PU7320 Floor Coating should always be applied in two layers. The application of the second layer may min. 16 hours and max. 24 hours be performed after the application of the first layer. Use a transparent Arturo sealer as second layer.
  • Check the conditions in space (temperature / humidity / dew point).
  • Take precautions for safe handling of the product.

Processing step-by-step

1. Packaging containing B-component and sieve.

1. Packaging containing B-component and sieve.

2. Stir component A thoroughly.

2. Stir component A thoroughly.

3. Pour the B-component in the A-component in the bucket.

3. Pour the B-component in the A-component in the bucket.

4. Mix the A and B component at least two minutes.

4. Mix the A and B component at least two minutes.

5. Pour the mixed sealer in a clean bucket through the sieve.

5. Pour the mixed sealer in a clean bucket through the sieve.

6. Then mix the material once again. Allow the mixture to age after mixing for about 10 minutes.

6. Then mix the material once again. Allow the mixture to age after mixing for about 10 minutes.

7. Apply to the floor edges using a brush.

7. Apply to the floor edges using a brush.

8. Then immediately roll with a 10 cm wide nylon roller (14 mm pile height).

8. Then immediately roll with a 10 cm wide nylon roller (14 mm pile height).

9. Apply the material thinly and evenly with a saturated 25 cm wide nylon roller (14 mm pile height) working cross-wise to get a closed layer (100 – 120 g/m² ) over the whole surface.

9. Apply the material thinly and evenly with a saturated 25 cm wide nylon roller (14 mm pile height) working cross-wise to get a closed layer (100 – 120 g/m² ) over the whole surface.

10. Within 10 minutes roll the surface again, using a 50 cm wide nylon roller (14 mm pile height) lightly wetted with material, in only one direction and without applying pressure.  Wear blunt spiked shoes to walk on the freshly applied coating.

10. Within 10 minutes roll the surface again, using a 50 cm wide nylon roller (14 mm pile height) lightly wetted with material, in only one direction and without applying pressure. Wear blunt spiked shoes to walk on the freshly applied coating.

More information?